THIS BATCH OF SE KITS IS SOLD OUT. If you ordered one, rest assured, you will receive one. However, if you are looking for a kit, look to one of our many retailers to secure one. We will have a second batch around December and we will set up a pre-order for them soon.
Get ready to up your racing program with the RX28SE Gen 3, the ultimate 1/28th-scale RC car engineered for enthusiasts who crave precision, versatility, and style. This third-generation marvel takes performance to new heights with cutting-edge upgrades that let you fine-tune your ride and conquer any track with confidence.
Feel the difference with the redesigned front end, featuring 1mm longer arms for enhanced stability and a new sway bar system that keeps your cornering razor-sharp. Dial in your setup with adjustable caster (3 screws), an integrated shock tower with shim adjustment, and adjustable upper arm hinge pin height for effortless camber gain and roll center tweaks. The low-profile big bore shocks and springs deliver silky-smooth handling, soaking up bumps while keeping you glued to the track.
The rear end sees many improvements as well. A new, much lower CG Rear
End sees an all new motor mount that lowers the motor by 0.8mm, new damper mount secured by 3 screws for easier service to the rear suspension, a tweak brace dropped 1.25mm, shorter side springs, thinner spring perches, side dampers lowered by 3mm (secured by screws on the motor mount), and smaller diameter centre shock spring, collar and perch, all which allow for higher corner speeds and quicker direction changes. Finally, a pinned Rear Motor Pod Plate increases precision and durability on the car.
The SE features our signature 24mm Steel tub chassis (for industry leading low cg, rigidity, precision and durability) both our premium ball differential and gear differential and 2 sets of plastics in both black and gray (excluding lower arms).
Dimensions:-98mm Wheelbase
-145g-170g weight RTR Depending on body and Electronics
-69mm to 78mm Rear Track Width
-72mm to 75mm Front Track Width
Need to Complete:
-Body
-Electronics: Motor, Lipo Battery, ESC, Receiver and Servo (Please note, the provided servo horn is designed to work with the Reflex Racing RRE007 Servo 20T Spline. Additionally, the AGFC A06CLS V1, the GL, the PN Anima and the Atomic Servo (it is a little bit of a tight fit but same sized spline) will fit as well.
****ELECTRONICS ARE NOT INCLUDED!!!
*IMAGES ARE PRODUCTION SAMPLES - Some Features are not visible.
Shopping CartItems0
